Raspberry Pi 3B+ – Transparent Acrylic Case – compatible with 3.5 inch display

Includes:

1. Acrylic Case
   1. Base -1, Long side – 2, Short side – 2
2. Bolts – 4
3. Metal nuts – 4
4. Acrylic nuts – 4

Assembly:

• Insert the acrylic nuts into the bolts.
• After aligning the board as shown in the Picture below, place the acrylic base over the bolts.

• Place the Raspberry Pi Board over the acrylic base.
• Insert the metal screws over the bolts and tighten as shown in Picture below.

• Arrange the long sides of the acrylic case as shown in picture below and insert the long sides into the base.

• Place the top of short side acrylic case and push the bottom in to the long sides as shown.

• Insert the next short side and the Acrylic case is fully assembled.

Disassembly:

• Invert the unit upside down.
• Push down on the 2 sides and open the side acrylic case as shown in the picture below.

 

• Remove the long sides and dismantle the screws and base.